To Next PageTo Next Page
Need help?Do you have a question about the Flymo Turbo Lite 250 and is the answer not in the manual?
General| Power | 1400 W |
|---|---|
| Cutting Width | 25 cm |
| Cutting Height | 11-31 mm |
| Cable Length | 10 m |
| Blade Type | Metal |
| Cutting Height Steps | 3 |
| Power Source | Electric |
| Grass Collection Capacity | Not applicable |
General safety guidelines for operators and children, including supervision and proper use.
Electrical safety measures, including R.C.D. use, cable inspection, and disconnection procedures.
Wear substantial footwear and long trousers; avoid open sandals or being barefoot.
Inspect for wear or damage; replace worn blades in sets for balance.
Use in daylight or good light; avoid wet grass if possible due to footing.
Exercise caution on slopes, wear non-slip footwear, and maintain a stable stance.
Secure lower handles to the hood using the fixing pin and slots.
Align and attach upper handles to lower handles using bolts, washers, and knobs.
Add/remove spacers for lower/higher cuts; ensure blade is fitted correctly.
Loosen blade bolt to remove blade, fan, and spacers for inspection and cleaning.
Correctly locate fan, spacers, and blade, then secure with blade bolt.
Push handle inwards from both sides to move it to the forward position.
Push handle inwards from both sides to move it to the down position.
Pull down or lift up handle to the most comfortable operating position.
Connect cable, secure it, connect to mains, tilt slightly, press lock-off, squeeze lever, and lower to lawn.
Start near the power point, mow edge first, cut grass twice weekly, avoid cutting more than a third of length.
Clean grass clippings from intakes and under hood; wipe with dry cloth; never use water or chemicals.
Replace parts, clean thoroughly, check air filter, and coil cable properly.
Carry with blade facing away; store in a dry place, protected from damage.
Check power, fuse, and starting procedure; consult service centre for recurring issues.
Clean underside, raise cutting height, or consult service centre if issue persists.
Check plastic cutters; disconnect and consult service centre if vibration continues.
Recommend annual servicing by a professional for optimal performance.
Product recycling information, packaging, and disposal guidelines for environmental protection.
Covers manufacturing defects reported to authorised repairers with proof of purchase.
Excludes misuse, wear and tear, unauthorized repairs, hire use, and commercial use.
Lists key specifications including width of cut, power, sound levels, and vibration.
Declares compliance with EU directives for machinery, EMC, noise, and hazardous substances.
