Flymo Mini Trim ET21 - Technical Data, Accessories, and Service; Technical Data

Turbotrimmer Unit Value (ET21)
Motor power consumption W 230
Mains voltage V 230
Mains frequency Hz 50
Cutting filament thickness mm 1.5
Cutting width cm 21
Cutting filament supply m 5
Cutting filament feed Manual filament feed system
Speed of cutting filament rpm 12,300 – 13,300
Weight kg 1.75
Sound pressure level L
pA
1)
Uncertainty k
pA
dB(A)
82.7
3.0
Sound power level L
WA
2)
measured / guaranteed
Uncertainty k
WA
dB(A) 90 / 92
2.0
Hand / arm vibration a
vhw
1)
Uncertainty k
a
m/s
2
< 2.5
1.5
Measuring process complying with
1)
EN 50636-2-91
2)
RL 2000/14/EC / S.I. 2001 No.1701
The stated vibration emission value has been measured according to a standardized test
pro cedure and can be used for comparison of one electric power tool with another. It can also
be used for preliminary evaluation of exposure. The vibration emission value can vary during
actual use of the electric power tool.
7. TECHNICAL DATA
Problem Possible Causes Remedy
Continuous clattering noise Motor has not reached full speed
before use.
v Allow the motor to reach full speed
before use.
Too much filament has been fed out.
v Rewind the filament.
Filament limiter is missing.
v Contact your local approved
Service Center or Husqvarna UK Ltd.
Customer Service.
Filament snaps continuously You do not use the correct working
position.
v Use the correct working position.
Filament is jammed on the filament
cassette.
v Rewind the filament to remove
crossed loops. Check that the fila-
ment is neatly winded. If it does not
help change the filament cassette.
Poor performance The cassette holder is dirty.
v Clean the cassette holder.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer Service.
Repairs must only be done by Husqvarna UK Ltd. service departments or specialist dealers
approved by FLYMO.
7
41121-85.960.01.indd 741121-85.960.01.indd 7 20.09.21 11:3820.09.21 11:38