4. MAINTENANCE
WARNING! Risk of physical injury!
Cut injury when the impeller turns or the
product starts accidentally.
v Wait for the impeller to stop, disconnect the
product from the mains and use gloves before
you do maintenance.
To clean the product [ Fig. M1 / M2 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to the
product.
v Do not clean the product with water or with a
water jet (in particular high-pressure water jet).
The airflow slots must always be clean.
1. Remove the tubes and the collection bag.
2. Clean the airflow slots
z
and the air intake / outtake
area
u
with a soft brush (do not use a screwdriver).
Remove all debris from the impeller.
3. Clean the blower head with a damp cloth.
4. Clean the tubes. Remove all debris from the tubes.
5. Turn the collection bag inside out and clean it with water.
3. OPERATION
WARNING! Risk of physical injury!
Cut injury when the impeller turns or the
product starts accidentally.
v Wait for the impeller to stop, disconnect the
product from the mains and use gloves before
you connect or transport the product.
To connect the product [ Fig. O1 ]:
DANGER! Risk of electric shock!
To avoid damage to the mains cable
w
it
must be inserted into the cable lock
e
.
v Before you operate the product insert the mains
cable
w
into the cable lock
e
.
1. Loop the mains cable
w
, insert the loop into the cable
lock
e
and pull tight.
2. Connect the mains cable
w
into a 230 V mains socket.
To start the product [ Fig. O1 ]:
To start:
v Push the start switch
r
to the ON-position.
To stop:
v Push the start switch
r
to the OFF-position.
Work positions:
Blow mode [ Fig. O2 ]:
Use your product as a blower for sweeping debris or grass
clippings from driveways, sidewalks, patios, etc. Also, for
blowing grass clippings, straw, or leaves into piles, or
remov ing debris from corners, around joints, or between
bricks.
Direct air flow by directing the blower tube down or to one
side.
Always work away from solid objects such as walks, large
stones, vehicles, and fences.
Clean corners by starting in corners and moving outward.
This will help prevent an accumulation of debris which
could fly into your face. Be careful when working near
plants. The force of the air could damage tender plants.
Vacuum mode [ Fig. O3 ]:
Use your product as a vacuum to pick up dry material such
as leaves, grass, small twigs, and bits of paper.
For best results during vacuum use, operate your unit at
high speed.
Move slowly back and forth over the material as you vacu-
um. Avoid forcing the unit into a pile of debris as this can
clog the unit.
Keep the vacuum tube about an inch above the ground for
best results.
WARNING: If the product becomes clogged, stop the
unit and unplug the extension cord. Wait until the
impeller has completely stopped turning, then
remove the vacuum tubes. Carefully reach into the
vacuum opening and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
To remove the collection bag
9
, push the tube release
button
8
and pull out the elbow tube
7
at the same
time.
To attach the shoulder strap [ Fig. A6 ]:
For extra support when you use the product as a vacuum,
a shoulder strap is included with your product. Attach the
strap to the product before operation.
v Snap the hook onto the retainer
q
.
6
51300-85.960.01.indd 651300-85.960.01.indd 6 07.09.21 11:1507.09.21 11:15
To Next Page
Loading...
