Problem Possible Causes Remedy
Product does not start Blower tube, elbow tube or vacuum
tube is not assembled correctly.
v Assemble the tubes correctly
(see 2. ASSEMBLY).
Collection bag is full.
v Empty the collection bag.
Extension cable is disconnected.
v Connect the extension cable.
Mechanical failure.
v Contact your authorized service
dealer.
Product vibrates abnormally Debris in air intake area.
v Clean the product. Remove any
debris.
Mechanical failure.
v Contact your authorized service
dealer.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer Service.
Repairs must only be done by Husqvarna UK Ltd. service departments or specialist dealers
approved by FLYMO.
6. TROUBLESHOOTING
WARNING! Risk of physical injury!
Cut injury when the impeller turns or the
product starts accidentally.
v Wait for the impeller to stop, disconnect the
product from the mains and use gloves before
you do troubleshooting.
5. STORAGE
To put into storage:
The product must be stored away from children.
1. Disconnect the mains cable.
2. Clean the product.
3. Stow the product in a dry area where it has protection
from frost (Do not stow a dirty collection bag).
Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to normal
household waste. It must be disposed of in line
with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal
recycling collection centre.
7
51300-85.960.01.indd 751300-85.960.01.indd 7 07.09.21 11:1507.09.21 11:15
To Next Page
Loading...
