6
Small
Opening
Zipper
Opening
Elbow Tube
Tube
Release
Button
Hole
3. Close the zipper on the bag. Make
sure the zipper is closed completely.
4. Alig n the grooves on the elbow tube
with the grooves on the bloweroutlet.
5. Push the elbow tube onto the blower
outlet until it snaps into place (elbow
tube is sec ured by orange tube re-
lease button).
Adjusting the shoulder strap on the
collection bag
1. Carefully loop the shoulder strap
through the buc kle as shown in theil-
lustration below.
First In
Last In
2. Position the unit on your right-hand
side, blower outlet and bag pointing
toward the rear. Hold the unit in an
upright position with the lower vacu-
um tube on the ground to support it.
3. Place the shoulder strap over your
head and onto your left shoulder.
4. Adjust the strap to allow a free flow of
air from the blower. If the collection
bag is kinked,the unitwillnotoperate
properly.
NOTE: The str ap is designed to posi-
tion the collecti on bag on your shoulder
wit hout kinks. The strap is not int ended
to support the weig ht of the uni t.
Shoulder strap
on left shoulder
No kinks in bag
allows free air flow
How to convert unit from vacuum use
to blower use
1. Ensure uni t is stopped and the mains
electr i cit y supply is disconnected.
2. Remove the vacuum tubes by insert-
ing the ti p of a screwdri ver into the
latch ar e a on the vacuum assist han-
dle. Gently tilt handle of screwdriver
towar d the front of the unit to release
the latch while pulling up on the vacu-
um assist handle wit h your ot her hand.
Latch Area
Vacuum
Assist
Handle
3. Install the inlet restrictor that was re-
moved when assembl ing for vacuum
use.
NOTE: If you are unable to locate the
inlet restrictor, the unit will still operate.
This restrictor improves the blower
function.
4. Remove the collection bag.
5. Close the inlet c over and make sure
it is latched closed.
6. Re-i nstal l t he blower tube. Refer to
AT-
TACHING THE BLOWER TUBE
for
instruct ions on how to att ach this i tem.
Cable restraint
1. Form loop in mains cable and push
the loop through t he slot.
2. To secure, positi on loop over the
hook and pul l the cable back
thr ough the slot as ill ust r ated.
Cable
Restraint
To Next Page
Loading...
