ENGLISH
13
SAFETY SYSTEM
07.01 Reactivating the kite
After triggering it, it is possible to reassemble the Quick Release
while on the water and start the kite again.
We recommend reading our Bar Safety Guide in detail!
Work your way up the safety endline until you get to the con-
trol bar. When you reach the bar, secure the endline to your har-
ness hook. Now the quick release can be reset with both hands.
Hook in the chickenloop and secure it with the chickendick.
Slowly release the endline bit by bit. Make sure that it has not
wrapped itself around any part of your body. Do not let the end-
line slip too quickly through your fingers to avoid getting burns
or cuts.
Tip:
It can happen that the kite tangles after flagging out. If this
cannot be solved by pulling on the steering lines, you can try to
solve the problem by flagging out the kite again.
Attach the safety leash to a suitable object (e.g. a post or
a board tightly buried in the sand) and work your way up to the
kite a.s.a.p.
Secure the kite as described in “Securing the Kite“.
07 SAFETY SYSTEM
The SONIC kites are equipped with a Frontline Safety (FLS).
After triggering the Quick Release, the Control Bar will slide up
to the stopper ball / knot.
The kite will flag out on this single front line.
To Next Page
Loading...
Need help?
General
