ENGLISH
15
PACKING UP
Grab the kite.
Lay the tips on top of each other, and then the bar on top and
roll up the kite. Be careful with the bridle lines and stow them
as best you can within the two halves of the kite when rolling it
up. You can open the deflate valves to make rolling it up easier.
Secure the package with the harness.
09 PACKING UP
A FLYSURFER kite can be packed into its bag very quickly. It is
important that the bridle is securely packed inside the kite and
the bar never gets into or goes through the bridle lines.
Open the deflate valves.
Wind the lines round the bar until you get to the mixer. Se-
cure the lines with the elastics or a half hitch. Keep hold of the
bar, or put it down somewhere out of the way of the bridle lines.
Fold the kite in half along the middle (tip on tip) and make
sure that the bridle is inside both halves. Also make sure that
there are no bridle lines over the outside skin.
Tip:
If you do not want to roll a wet bar into your kite, there is a
method to attach the bar to the outside of the bag. Fold the kite
in the middle (tip on tip) and then roll up the kite, including the
bridle, and put it into the bag. Then roll up the bar and attach it
to the outside of the kitebag.
To Next Page
Loading...
Need help?
General
