Flyzone DHC-2 Beaver - Mount the Wings

8
❑
5. Secure the stab and  n with the M3x22 screw.
Mount the Wings
❑
1. Fasten the wing clips to both sides of the fuselage
with four M3x10 screws.
❑
2. Guide the wires from the right wing into the fuselage,
then slide the wing joiner tube and the  ap pushrod wire
through the corresponding holes. Also guide the  ap pushrod
wire into the screw-lock connector on the  ap servo. Guide
the joiner tube through the hole in the left side of the fuselage,
then tightly “CLICK!” the wing onto the wing clips.