Flyzone Switch User Manual

Entire Contents © 2010 Hobbico
®
, Inc. HCAA2530 Mnl 2.0
READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT
INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.
WARRANTY
Hobbico guarantees this kit to be free from defects in both
material and workmanship at the date of purchase. This warranty
does not cover any component parts damaged by use or
modification. In no case shall Hobbico’s liability exceed the
original cost of the purchased kit. Further, Hobbico reserves
the right to change or modify this warranty without notice.
In that Hobbico has no control over the final assembly or material
used for final assembly, no liability shall be assumed nor
accepted for any damage resulting from the use by the user of
the final user-assembled product. By the act of using the
user-assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to return
this kit immediately in new and unused condition to the
place of purchase.
To make a warranty claim send the defective part or item to
Hobby Services at the address below:
Hobby Services
3002 N. Apollo Dr. Suite 1
Champaign IL 61822 USA
Include a letter stating your name, return shipping address, as
much contact information as possible (daytime telephone
number, fax number, e-mail address), a detailed description of
the problem and a photocopy of the purchase receipt. Upon
receipt of the package the problem will be evaluated as quickly
as possible.
™
Champaign, Illinois (217) 398-8970
E-mail: airsupport@hobbico.com
SPECIFICATIONS
Wingspan: 45 in [1145 mm]
Wing Area: 419 sq in [27 dm
2
]
Wing Loading: 14 oz/sq ft [43 g/dm
2
]
Length: 42 in [1065 mm]
Weight: 2.5 lbs [1130 g]
Battery: 3S - 11.1V 1800mAh LiPo
Radio: 4 Channel
Motor: SuperTigre
®
.10
ESC: SuperTigre 30 ESC
INSTRUCTION MANUAL
TRAINER EP RTF

Flyzone Switch Specifications

General

Brand	Flyzone
Product Name	Switch
Category	Toy
Wingspan	39.4 in (1000 mm)
Length	30.7 in (780 mm)
Weight	22.2-23.3 oz (630-660 g)
Power Source	Electric
Type	Airplane
Battery	1300mAh 11.1V LiPo
Transmitter	2.4GHz

Summary

Assemble the Model

Install the Landing Gear

Procedures for attaching the landing gear components, including wheels and pants, to the fuselage.

Install the Tail Section

Steps for attaching the horizontal stabilizer and rudder assembly to the fuselage using joiner rods and pushrods.

Set Up High Wing Configuration

Assembling the aircraft in its high-wing configuration, connecting servos and canopy.

Install the Propeller

Guide to attaching the propeller, prop adapter, spinner backplate, and cone to the motor shaft.

Change to Low Wing Configuration

Transitioning the aircraft from high-wing to low-wing setup for aerobatic flight capabilities.

Get the Model Ready to Fly

Transmitter and Battery Preparation

Installing transmitter batteries, charging the LiPo battery, and safe handling practices.

Radio Control Setup and Checks

Configuring the 4-channel radio, checking control surface directions and throws.

ESC and Motor Configuration

Setting up the ESC, transmitter settings, brake function, and safe-start procedures for the motor.

Balance the Model (C.G.)

Control Surface Throws

Recommended measurements for elevator, rudder, and aileron control surface deflections.

Balance Model Laterally

Ensuring the aircraft is balanced side-to-side for stable flight characteristics.

Preflight Checks

Model Identification

Required procedure to label the model with ownership information for identification.

Propeller Balancing

Balancing the propeller to prevent vibration that can damage the model or components.

Range Check Procedure

Testing the radio transmitter's range to ensure reliable control at a distance.

Motor Safety Precautions

Essential safety guidelines for operating the motor and propeller to prevent injury.

AMA Safety Code Excerpts

Key safety rules from the Academy of Model Aeronautics for responsible flying.

Checklist for Preparation

A final list of critical checks to perform before the model's first flight.

Flying Operations

Takeoff Procedures

Step-by-step guide for initiating takeoff, including ground handling and lift-off.

Flight Handling and Adjustments

Tips for initial flights, trimming the model, and making adjustments for optimal performance.

Landing Approach and Execution

Instructions for initiating a landing approach and safely touching down the aircraft.