EasyManua.ls Logo

Flyzone Switch - Get the Model Ready to Fly; Transmitter and Battery Preparation

Flyzone Switch
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
GET THE MODEL READY TO FLY
Prepare the Transmitter
and LiPo Battery
1. Install fresh AA batteries into the transmitter. Follow
the diagram molded inside the battery compartment.
2. Familiarize yourself with the charging procedure of the
included LiPo battery. Read the charger manual completely.
3. Fully charge the LiPo battery.
4. Install the included soft side of the hook and loop
material to your battery pack. Test fi t the battery in the
airplane. When it is time to balance the model, you may need
to shift the battery forward or aft to achieve the balance point
provided later in the manual.
Lithium Battery Handling & Usage
WARNING!! Read the entire instruction sheet included with
the battery. Failure to follow all instructions could cause
permanent damage to the battery and its surroundings, and
cause bodily harm!
ONLY use a LiPo approved charger. NEVER use
a NiCd/NiMH peak charger!
NEVER charge in excess of 4.20V per cell.
ONLY charge through the “charge” lead. NEVER
charge through the “discharge” lead.
NEVER charge at currents greater than 1C.
ALWAYS set charger’s output volts to match
battery volts.
ALWAYS charge in a fi re proof location.
NEVER trickle charge.
NEVER allow battery temperature to exceed
150°F (65°C).
NEVER disassemble or modify pack wiring in any
way or puncture cells.
NEVER discharge below 2.75V per cell.
NEVER place on combustible materials or leave
unattended during charge or discharge.
ALWAYS KEEP OUT OF REACH OF CHILDREN.
Check the Control Directions
1. With the battery fully charged, turn on your transmitter
and move the throttle stick (left stick) down to the idle
position. Then, plug the motor battery into the ESC. If
the ESC makes a continuous beeping sound, the throttle
channel needs to be reversed on the transmitter, following
Step 2. If not, skip Step 2.
2. Disconnect the battery from the ESC. Then, move the
throttle reversing switch on the transmitter. Confi rm that the
throttle stick is still in the idle position and reconnect the
battery to the ESC.

Related product manuals