• Never charge a lithium polymer battery with a charger designed for Nicd, NIMH, or any other type of battery
chemistry.
• Use ONLY charger designed for LiPo battery.
• Do not leave LiPo battery unattended during charging.
• Do not overcharge the battery.
• Always charge LiPo batteries on non-flammable, heat-resistant surfaces.
• Always use a LiPo-safe bag or container while charging.
• Do not allow LiPo cells to overheat at any time.Cells which reach greater than 140 Fahrenheit(60℃) will usually
become damaged and will catch fire.
• Do not charge the LiPo pack while it is still in the model.
• Never charge or store battery packs in a vehicle.
• Do not discharge LiPo, doing so will damage the battery.
• Do not expose LiPo cell to water or moisture at any time.
• Do not store battery near open flame or heater.
• Do not assemble LiPo cells or pre-assembled packs together with other LiPo cells or packs.
• Always store LiPo battery in a secure location away from children.
• Always remove the LiPo battery if model is involved in any kind of crash.
• Carefully inspect the battery and connectors for even the smallest damage.
• CAUTION: Cells may become hot after usage.
Step 1: turn on the transmitter, the headlamp of the transmitter will flash and enter search mode.
Step 2: turn on the receiver switch, the front lights of the vehicle will flash and enter search mode.
Step 3: when the transmitter and receiver are successful connected, the headlamp of the transmitter will be
on for a long time, and the front lights of the vehicle will be on for a long time.
步骤1：打开发射器，发射器前灯会闪亮，进入搜索模式。
步骤2：打开接收器开关，车前灯会闪亮，进入搜索模式。
步骤3：当发射器，接收器对上频成功时，发射器前灯会长亮，车前灯会长亮。
Battery Precautions
电池注意事项
Operating the vehicle
车辆操作
Motor is cogging when accelerated
quickly.
1.The battery has limited discharge ability.
2.Motor RPM is too high, the gear ratio is
too aggressive. 3.Something wrong in the
driving system of the car.
1.Use battery with better discharge ability.
2.Use motor with lower RPM, or use
smaller pinion to get softer gear ratio.
3.Check the driving system of the car.
1. 电池放电能力不够。2. 电机转速过高，齿
轮比搭配过于激进。3. 车子传动系统有问题。
1. 更换放电能力强的电池。2. 更换低速电
机，或将减速比提高。3. 检查车架传动系
统是否顺畅。
1. 检查马达和电调之间的接头，确保连接
可靠。2. 更换新马达。
16
Instructions
遥控产品规格
Trouble
故障现象
电机启动时急加速，电机有卡住或停顿
的现象。
The car cannot get top speed and the
red LED doesn’t solid on at full throttle
车子无法前进也无法倒车，指示灯正常。
Some setting in the transmitter are
incorrect.
遥控器油门通道方向设置错误。
1.Check the connections and replace the
defective connectors. 2.Replace the motor.
可能原因 解决方法
Possible Reason Solution
VEHICLE SETUP
车辆设置
To Next Page
Loading...
