Before operation, install the battery and connect the system as instructed below.
Battery Type: AA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AA batteries into the compartment. Make sure that the battery makes good contact with the
battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the G.LED on the panel will flash slowly.
电池类型使用: AA电池
请按照以下步骤安装发射机电池：
1.打开电池仓盖。
2.将4颗电量充足的AA电池装入电池仓内，确保电池上的金属端子与电池仓内的金属端子接触。
3.盖好电池仓盖。
低电量报警:当电量低于4.2V时，面板上的G.LED慢闪报警提示。
开始操作前，请按照本章的顺序和指引安装电池、连接设备。
Transmitter Battery Installation
发射机电池安装
Getting Started
使用前准备
7
Danger
危险
Danger
危险
Danger
危险
Danger
危险
Danger
危险
Danger
危险
Danger
危险
Only use specified battery (X4 AA batteries).
仅使用厂家指定的电池。
Do not open, disassemble, or attempt to repair the battery.
请勿打开、拆卸或自行维修电池。
Do not crush/puncture the battery, or short the external contacts.
请勿挤压、刺穿或接触电池的金属端子。
Do not expose to excessive heat or liquids.
请勿将电池置于高温环境或液体中。
Do not drop the battery or expose to strong shocks or vibrations.
如果不按照说明方法操作，可能导致操作者或他人遭受较大伤害。
Always store the battery in a cool, dry place.
请将电池存放在干燥阴凉的环境中。
Do not use the battery if damaged.
如果电池损坏，请立即停止使用。
To Next Page
Loading...
