fig6
6
4. The bottom of the fuselage faces up. Carefully apply CA to the base and side of the rear fuselage slot.
Install the stabilizer into place. Ensure the control horn is face up as shown (fig5).
Note: Ensure the stabilizer horizontal axis is parallel to the wing as shown (fig6). Adjust any misalignment
before the glue dries thoroughly.
5. Carefully apply CA to the top rear fuselage slot. Install the vertical stabilizer into place.
fig5
Required Adhesives:
Medium CA
fig7
Required Adhesives:
Medium CA
fig7
fig6
fig5
To Next Page