11
Getting Started
使用前准备
Installing the AA Battery
Follow the steps below to install the AA batteries:
1. Open the battery compartment cover as illustrated.
2. Insert 4 fully-charged AA batteries into the compartment. Make sure that the batteries are well set according to the
polarities marked on the battery compartment.
3. Replace battery compartment cover.
Installing the LiPo Battery
Follow the steps below to install the LiPo battery:
1. Open the battery compartment cover.
2. Insert 2S fully-charged LiPo battery into the compartment.
3. Plug the cable of LiPo battery into the JST Jack. Make sure to connect correctly according to the polarities marked
on the battery compartment.
4. Replace battery compartment cover. Be careful not to pinch the cable.
AA 电池安装
请按照以下步骤安装 AA 电池：
1. 打开电池仓盖 ( 如图所示）；
2. 将 4 颗电量充足的电池按标注的极性方向装入电池仓内；
3. 盖好电池仓盖。
LiPo 锂电池安装
请按照以下步骤安装锂电池：
1. 打开电池仓盖。
2. 将 2S 电量充足的锂电池放入电池仓内，
3. 将电池连接线接入 JST 接口，确保正确连接正负极；
4. 盖好电池仓盖，注意不要夹到电池连接线。
Transmitter Battery Installation
发射机电池安装
Danger
注意
Only use specified battery (X4 AA batteries).
仅使用厂家指定的电池。
Danger
注意
Do not open, disassemble, or attempt to repair the battery.
请勿打开、拆卸或自行维修电池。
Danger
注意
Do not crush/puncture the battery, or short the external contacts.
请勿挤压、刺穿或接触电池的金属端子。
Danger
注意
Do not expose to excessive heat or liquids.
准请勿将电池置于高温环境或液体中。
Danger
注意
Do not drop the battery or expose to strong shocks or vibrations.
请注意防止电池跌落、碰撞或振动。
Danger
注意
Always store the battery in a cool, dry place.
请将电池存放在干燥阴凉的环境中。
Danger
注意
Do not use the battery if damaged.
如果电池损坏，请立即停止使用。
按住此处并向前滑动，取下电池舱盖。
Press to slide the cover as
illusrtated. Then remove the cover.
To Next Page
Loading...
