EasyManua.ls Logo

FMS FCX10 - Page 28

FMS FCX10
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• Never charge a lithium polymer battery with a charger designed for NiCd, NiMH, or any other type of battery
chemistry.
• Use ONLY charger designed for LiPo battery.
• Do not leave LiPo battery unattended during charging.
• Do not overcharge the battery.
• Always charge LiPo batteries on non-flammable, heat-resistant surfaces.
• Always use a LiPo-safe bag or container while charging.
• Do not allow LiPo cells to overheat at any time.Cells which reach greater than 140 Fahrenheit(60) will usually
become damaged and will catch fire.
• Do not charge the LiPo pack while it is still in the model.
• Never charge or store battery packs in a vehicle.
• Do not discharge LiPo, doing so will damage the battery.
• Do not expose LiPo cell to water or moisture at any time.
• Do not store battery near open flame or heater.
• Do not assemble LiPo cells or pre-assembled packs together with other LiPo cells or packs.
• Always store LiPo battery in a secure location away from children.
• Always remove the LiPo battery if model is involved in any kind of crash.
• Carefully inspect the battery and connectors for even the smallest damage.
• CAUTION: Cells may become hot after usage. • Allow the pack to cool to room temperature prior to recharging.
• Do not allow the electrolyte to get into eyes or on skin. Wash affected areas immediately if they come into contact
with electrolyte.
• Do not alter or modify connectors or wires of a LiPo battery pack.
• Always inspect the condition of the battery before charging and operating.
• Do not short circuit the LiPo battery.
• Do not have contact with a leaky/damaged battery directly.
• Do not charge battery out of recommended temperature range(0-45)
• 不要使用NiCd、NiMH或任何其他类型的充电器给LiPO锂聚合物电池充电。
• 请使用LiPO锂聚合物的专用充电器给LiPO锂聚合物电池充电。
• 请勿在无人看管的情况下充电。
• 电池请勿过充。
• 请勿将电池放置在易燃、不耐热的表面上充电。
• 总是使用安全袋或安全容器给电池充电。
• 保证电池在任何时候都不过热。电池温度超过140华氏度(60℃)则易造成损坏,甚至引发火灾。
• 请勿将电池长期置于模型产品内,更勿在模型产品内直接充电。
• 请勿给电池放电,以免损坏电池。
• 任何时候请勿将电池暴露在水或湿气之中。
• 请勿在明火或加热器附近储放电池。
• 请勿与其他未组装或预组装的电池混用。
• 需将电池存放在远离儿童的安全位置。
• 模型如出现任何碰撞,需立刻拆除电池。 即使出现微小的损坏,也需仔细检查电池和连接器。
• 注意:使用后电池可能会发热,需让电池冷却到室温后再进行充电。
• 请勿让电解液接触眼睛或皮肤。如电解液不慎接触到身体的任何部位,请立即进行清洗。
• 请勿替换或修改电池组的连接器或电线。
• 在进行充电或其他任何操作之前需检查电池的状况。
• 请勿造成电池短路。
• 请勿直接接触已泄漏或已损坏的电池。
• 请勿超出建议温度范围充电电池(0度-45度)。
Battery Precautions
电池注意事项
27
Vehicle Setup
车辆设置

Related product manuals