本接收机具有电池电压过低和过高保护功能。
• 电压过低保护：当检测到电池电压过低时，CH2 马达通道无输出，CH1 通道、CH3 通道、CH4 通道正常输
出，所有车灯慢闪提示。
• 电压过高保护：当检测到电池电压过高时，所有通道无输出，所有车灯快闪提示。
本接收机电调具有过热保护和堵转保护功能。
• 过热保护：当检测到整机温度过高时，CH2 马达通道无输出，CH1 通道、CH3 通道、CH4 通道正常输出，
所有车灯快闪提示；当温度正常后，CH2 马达通道恢复输出。
• 堵转保护：当外部马达堵转时，进入堵转保护状态，用于保护电调和马达，CH2 马达通道无输出，CH1 通
道、CH3 通道、CH4 通道正常输出；待无堵转时，CH2 马达通道恢复正常输出。
The car light control is mainly to implement the changeover of lighting states and lighting modes by the setting
of the transmitter. All car lights will be on for 1second as the self-check display when the receiver is powered on.
This receiver is preset with five modes for controlling model car lights. In each mode, the on/off states of backup
lights are consistent; in other words, the backup light is in solid on state when the model car backs up.
Otherwise, it is in off state. The turn signal light, headlight and roof light have different on/off states as follows.
• Default mode: In this mode, the turn signal light is in off state regardless of whether the model car makes a turn
or not; When backing up, the backup light is in solid on state, and otherwise, it is in off state; The headlight
and roof light are in off state.
• Mode A: In this mode, the turn signal light is in a slow flashing state when the model car makes a turn; When
backing up, the backup light is in solid on state, and when not backing up, it is in off state; The headlight and
roof light are in a low-light state.
• Mode B: In this mode, the turn signal light is in a slow flashing state when the model car makes a turn; When
backing up, the backup light is in solid on state, and when not backing up, it is in off state; The headlight and
roof light are in high-light state.
• Mode C: In this mode, the turn signal light is in a continuously slow flashing state regardless of whether the
model car makes a turn or not; When backing up, the backup light is in solid on state, and when not backing
up, it is in off state; The headlight and roof light are in high-light state.
• Mode D: In this mode, the turn signal light is in a slow flashing state when the model car makes a turn; When
backing up, the backup light is in solid on state, and when not backing up, it is in off state; The headlight and
roof light are in off state.
Notes:
1. Press the CH4 button of the transmitter to switch the working mode, one mode per press (Default Mode,
Mode A, Mode B, Mode C and Mode D are switched in turn).
2. Every time the receiver is turned on, the car light control mode is in Default Mode.
3. Mode C is an emergency light working state. In this mode, the left and right turn signal lights flash synchro-
nously and slowly as emergency lights.
4. This receiver identifies the neutral positions of Steering CH1 and Throttle CH2 automatically when it is
powered on. It recommends to power on the receiver again after the trims of the transmitter are adjusted.
Function Instructions
功能说明
21
Car Light Control
车灯控制
To Next Page
Loading...
