本款接收机上电即自动进入对码状态。
1.将发射机进入对码状态（发射机进入对码状态的方式可能不同，请根据发射机的使用说明书进行操作）；
2.接收机上电等待1 秒没有连接将自动进入对码；
3.接收机 LED灯常亮，即对码成功（发射机对码成功后自动退出对码状态）；
4.检查发射机、接收机是否正常工作。如需重新对码，请重复以上步骤。
注：
1.对码时请先将发射机进入对码状态，再将接收机进入对码状态，若 10s 内对码没有完成，接收机指示灯进入慢
闪状态；
2. 因本款接收机仅支持单向对码，若对码的发射机支持单双向模式切换，请先在发射机端设置为单向模式后再开
始对码。
• 使用前必须确保本产品与模型安装正确，否则可能导致模型发生严重损坏。
• 关闭时，请务必先关闭接收机电源，然后关闭发射机。如果关闭发射机电源时接收机仍然在工作，将会导致遥
控设备失控。失控保护设置不合理可能引起事故。
• 确保接收机安装在远离电机，电子调速器或电子噪声过多的区域。
• 接收机天线需远离导电材料，例如金属棒和碳物质。为了避免影响正常工作，请确保接收机天线和导电材料之
间至少有 1厘米以上的距离。
• 准备过程中，请勿连接接收机电源，避免造成不必要的损失。
The receiver automatically enters the binding state once it is powered on.
1.First put the transmitter into binding mode (See the transmitter s user manual for instructions on how to
activate binding mode.)
2.When the receiver is powered on and waits for 1 second t will automatically enter the binding state ifit
is not connected.
3.The receiver LED is solid on after the binding is successful (The transmitter automatically exits the
binding state after the successful binding).
4. Verify that the transmitter and receiver are working properly. lf you need to re-bind, repeat the above
steps.
Notes :
1.Set the transmitter to its binding state first, and then set the receiver to its binding state. lf the binding is
not finished within 10s. the LED of the receiver will enter its slow flashing state.
2.Because this receiver only supports one-way binding, if the binding transmitter supports one-way and
two-way mode binding, please set the one-way mode at the transmitter side before starting the binding.
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
• Make sure the receiver s batery is cisconnected berore turning off the transmitter, tailure to do so can
result out of contro
• Unreasonable setting of the Failsafe may cause accidents.
• Make sure the receiver is mounted away from motors, electronic speed controllers or any device that
emits excessive electrical noise.
• Keep the receiver s antenna at east 1cm awav from conductive materials such as carbon or metal.
• Do not power on the receiver during the setup process to prevent loss of control.
Binding
对码
Attention
注意事项
19
To Next Page
Loading...
