Throttle stick position
THROTTLE STICK POSITION
Neutral point Top point of forward direction Top point of backward direction
Getting started
Instructions
Transmitter Battery Installation
13
EN
Before operation, install the battery and connect the system as instructed below.
Danger
Danger
Danger
Danger
Danger
Danger
Danger
Only use specified battery (X4 AA batteries).
Do not open, disassemble, or attempt to repair the battery.
Do not crush/puncture the battery, or short the external contacts.
Do not expose to excessive heat or liquids.
Do not drop the battery or expose to strong shocks or vibrations.
Always store the battery in a cool, dry place.
Do not use the battery if damaged.
Battery Type: AAA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AAA batteries into the compartment. Make sure that the battery makes good
contact with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the LED on the panel will flash slowly.
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before
leaving thefactory.)
If you need to replace another transmitter or receiver, please follow the following steps to code:
1. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
2. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the
code matching mode;
3. When the code matching is successful, all the transmitter lights are on and all the lights on the car
are off;
Note: when code matching, please operate the transmitter to enter the code matching state first, and
then operate the receiver to enter the code matching state.
To Next Page
Loading...
