EasyManuals Logo

FNM HPE Series User Manual

FNM HPE Series
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
FNM
®
HPE Series 87
3. Remove the impeller with the appropriate puller. Mark the impeller with a pen on the side at
sighttorepositionit(onlyifitisn’tdamaged)inthesameway.
4. If the impeller is too worn, provide for replacement.
5. When using a new impeller, lubricate it with silicon spray grease before mounting it.
Figure 36 - Lubrication of the impeller
6. Install the new impeller on the grooved shaft.
7. Re-close the pump cap and replace the seal gasket if possible.
8. Open the sea water intake valve.
9. Restart the engine and check for any leaks.
Use only original FNM spare parts.

Other manuals for FNM HPE Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FNM HPE Series and is the answer not in the manual?

FNM HPE Series Specifications

General IconGeneral
BrandFNM
ModelHPE Series
CategoryEngine
LanguageEnglish

Related product manuals