FNM HPEP 250 - Table of Contents

2
INSTALLATION MANUAL HPEP 225 / 250
DIESEL ENGINE & BRAVO STERN DRIVES
Table of Contents
General Information ...................................
Notice Installer .........................................
Operation/Duty Cycle Rating Notice ........
Bravo Three Notice: Increased Trim-In Range
Capability ……………………………………
Multiple Sterndrive Steering Tie Bar
Arrangement ………………………..
Propeller Rotation on Dual Installations….
Quicksilver Products ................................
Torque Specifications… …………………
Serial Number Decal Placement ..............
Corrosion Protection ...............................
Anti-fouling Paint ....................................
Installation requirements ........................
Transom Thickness and Surface..............
Engine Bed ..............................................
Engine Compartment ...............................
Engine Compartment Ventilation..............
Exhaust System .......................................
Fuel Delivery System .............................
Battery ....................................................
Battery Cables ........................................
Instrumentation ........................................
Power Trim Control ...............................
Power Trim Pump Location ....................
Propeller Selection...................................
Transom Cutout .........................................
Cutting Transom ……………………………
Checking Transom Thickness ..................
Installing Transom Assembly ...................
Gimbal Housing Preparation………………
Installing Inner Transom Plate ……………
Installing Power Trim Pump .....................
Installing Steering System ......................
Connecting Speedometer Pickup ...........
Connecting Gear Lube Monitor Hose And
Installing Water Inlet Fitting…………………
Engine Installation ....................................
Shift Cable Installation ............................
Throttle Cable Installation and
Adjustment……………………………………
Sterndrive Installation ...............................
Predelivery Preparation .............................
Wiring Diagrams ........................................