Focal GRANDE UTOPIA BE - UNPACKING User Manual

Focal-JMlab
®
BP 374 - 108, rue de l’Avenir - 42353 La Talaudière cedex - France - Tel. 00 33 4 77 43 57 00 - Fax 00 33 4 77 37 65 87 - www.focal-fr.com
• Unpacking procedure.
Procédure de déballage.
• Accessories per speaker.
Accessoires par enceinte.
1 - Right the packaging. Beware the up and down
sides. 4 people required.
1 - Redressez l’emballage en respectant le sens.
4 personnes minimum.
2 - Unscrew the side panel of the box and
remove it.
2 - Dévissez le couvercle puis le retirer.
1 2
x 1 x 4 x 4 x 4
A B
C D
Unpacking Grande Utopia Be
Déballage Grande Utopia Be
4 - Lay down the loudspeaker sideways on
a surface protected with felt or foam for
example. 4 people required.
4 - Couchez l’enceinte sur le fl anc sur une surface
protégée (feutre, mousse...).
4 personnes minimum.
4
3 - Install the ramp as indicated. Carefully pull
out the loudspeaker thanks to the girth.
3 - Placez les encoches de la rampe sur les 2 ergots
au bas de l’emballage. Dégagez l’enceinte douce-
ment en tirant sur la sangle.
3
A

Focal GRANDE UTOPIA BE - UNPACKING Specifications

General

Frequency Response	18Hz - 40kHz
Nominal Impedance	8 Ohms
Type	Floorstanding
Recommended Amplifier Power	50 - 1000W
Dimensions (H x W x D)	260 kg
Net Weight	260 kg

Summary

Unpacking Grande Utopia Be

Right the packaging

Correctly orient the packaging, noting the up and down sides. Four people are required for this step.

Remove side panel

Unscrew the side panel of the box and remove it as part of the unpacking procedure.

Install ramp and pull out speaker

Install the ramp and carefully pull out the loudspeaker using the provided strap. Four people are needed.

Lay speaker on its side

Place the loudspeaker on its side on a protected surface, such as felt or foam. Four people are required.

Continue Unpacking and Setup

Unscrew lower plate

Unscrew the lower plate using a 22mm box spanner. This secures the base of the unit.

Assemble cones and insert

Assemble the cones without the spike and insert the assembly under the loudspeaker as shown.

Right speaker again

Carefully turn the loudspeaker upright again. This operation requires four people.

Install speaker at location

Position the loudspeaker at its final location and insert the spikes by lifting each corner.