FOCUS 4010/HT Dental Porcelain Furnace Page 3 Manual version 4.2.2013
Warning
ATTENTION!
ATTENTION!
Mount on non-flammable surface material only !
Take out the furnace with the assistance of two persons. To do so, each person
will take a side by holding the bottom of the furnace with one hand and the top
side with the other hand.
Do not pull out the furnace by its support in order to avoid damages.
When operating the furnace a Refractory support must always be on the lift tray!
During use, the area around the furnace table is hot; approach and contact with
the table should be only when the furnace is cold
Dental work must only be placed on the furnace table.
Avoid placing or resting objects on any area of the furnace except the rest
table.
In the event of an external power failure while the furnace is in operation:
1) Disconnect the power supply cord from the electrical power outlet.
2) Lower the table by inserting the crank supplied, into the hexagonal
screw located at the back of the furnace.
To Next Page
Loading...