Focus 4010 - Furnace Installation and Connection; Unpacking and Initial Placement

FOCUS 4010/HT Dental Porcelain Furnace Page 5 Manual version 4.2.2013
1. Furnace Installation
1.1 Unpacking
1) Check the contents of the shipping carton, compare with the enclosed list.
2) Take out the accessories and check the contents:
Remove carefully the polyethylene foam.
3) Lift out the furnace carefully, and positioning it on its feet. DO NOT lift the
furnace by the lift shaft.
4) Store the carton and the polyethylene foam for future use.
POINTS TO NOTE:
 When positioning the furnace on the working bench, please keep safe
distances from the surrounding walls (approx. 20cm).
 Do not place the furnace near the open window or any source of
direct airflow (like ventilator). This, in order to eliminate the
possibility of wrong temperature reading when the firing table is in its
lower position.
 Placing the furnace according to the above mentioned instruction will
guarantee the proper temperature stabilizing, heating and cooling.
1. Electrical Mains cord
2. Firing table
3. Tweezers
4. Fuses
5. Emergency wrench
6. Vacuum hose
7. User manual