TView Gold User’s Guide
Chapter 2
9
Inspecting the Equipment
Before installing and connecting the hardware, inspect it for
any damage which may have been incurred during shipment.
Perform a thorough inspection, looking for dents, scratches, or
loose parts. Look for anything that appears unusual or out-of-
the ordinary. If any of the equipment is damaged, contact
FOCUS Enhancement’s Customer Service department by
calling 1-800-338-3348.
Connecting the TView Gold to an IBM
PC or Macintosh Computer
This section describes the steps to connect your TView Gold to
a television or VCR. The following sections describe how to
connect to IBM PCs, Macintosh PCs, IBM PC laptops and
Notebooks, and Macintosh PowerBook’s.
Notes: 1. Before performing the steps to connect the
TView Gold to a laptop computer, you must enable
the external video connector. This is accomplished
by using a particular key sequence (hot key) on the
keyboard (for example, FN + F11) or through the
BIOS setup program. Refer to your laptop owner’s
manual to determine how the external video
connector is enabled.
To Next Page
Loading...