Fomotech Alpha 612E-2 - 10 Battery Charger; Charger Operation

- 44 -
10.
B
B
A
A
T
T
T
T
E
E
R
R
Y
Y
C
C
H
H
A
A
R
R
G
G
E
E
R
R
10.1 Charger Operation
Electromagnetic Induction Charge
 The electromagnetic induction charger with undisclosed metal charging contacts on transmitter provides
immediate charging simply by sliding in the transmitter into the charger. No need to open the battery
cover to replacing batteries.
 To avoid rain, high temperature, humidity and corroding air, please place or install the battery charger
indoor with good ventilation. Keep 5cm space for two sides of the charger to keep the heat out. The
suggesting temperature range is 0 ~ 40℃.
(Fig.
10) Front view
 Battery charger voltage AC100~240V 50/60Hz, power consumption 7W。
 Use Nickel-Metal Hydride (NI-MH) 2500mA, AA size*2 rechargeable batteries. Charging can be
completed in 5 hours.
 Set the power switch on the OFF position whenever transmitter is not operated. Press E-STOP button and
slide-in the transmitter into the charger to charge. The transmitter is suggested to be charged whenever it is
not operated.
 The charger status light shows red when transmitter is charging; transmitter status light will be off when
charging is completed or failed. Please refer to below Battery Charger LED Status Light for details.
After charging is completed, the charger status light shows green.
 Charger power LED: green