Why is my Fondital minorca rc Boiler remote control not connecting?
If you're experiencing a Remote Control connection failure on your Fondital Boiler (only shown on the Remote Control display), the Remote Control might not be connected to the boiler board (reconnect it), the remote control might be faulty (replace it), or the boiler board itself could be faulty (replace it).
How to fix a Fondital minorca rc when the burner does not ignite?
If the burner on your Fondital Boiler isn't igniting, several factors could be at play. It could be due to a gas supply failure, so check the gas supply, gas supply cock, or gas network safety valve. Other potential causes include a disconnected or faulty gas valve (reconnect or replace it, respectively), a faulty board or ignition relay (replace them). Also, the ignition transformer could be faulty, so replace the ignition transformer. The electronic board might be faulty or not detecting a flame due to inverted phase and neutral (replace the board or verify the correct neutral and phase connection). Check for a detection electrode cable interruption (reconnect or replace the wire) or a faulty detection electrode (replace the electrode). Finally, the ignition heat input setting could be t...
What to do if the water circulation in Fondital minorca rc is not correct?
If the water circulation in your Fondital Boiler is not correct, it could be due to system pressure being too low or water not circulating correctly in the system. Check the system in both cases.
What causes the temperature difference between flow and return to be out of limits in Fondital minorca rc?
If the temperature difference between flow and return is not within the limits in your Fondital Boiler, it could be due to faulty flow and/or return probes (replace them), an obstructed bypass pipe (remove any obstructions or replace the pipe), an incorrectly assembled bypass valve (restore correct bypass valve assembling), or an obstructed heat exchanger primary circuit (clean or replace the exchanger).
Why does the flow temperature increase too quickly in my Fondital Boiler?
If the flow temperature increases too quickly in your Fondital Boiler, it could be due to a seized pump (unseize the pump), a faulty pump (replace it), or air present inside the heating system (bleed the air from the boiler by opening the jollies on the exchanger and pump).
What to do if there are problems in the electronic board power supply of Fondital minorca rc Boiler?
If you're experiencing problems with the electronic board power supply in your Fondital Boiler, it could be due to unstable power mains. Check the power mains.
What causes air flow rate problems in Fondital minorca rc?
If you're experiencing problems with the air flow rate in your Fondital Boiler, it could indicate clogging on the flue gas side of the heat exchanger. Check the heat exchanger for blockages.
What does ambient probe fault mean on Fondital minorca rc?
If your Fondital Boiler shows an ambient probe fault (only with connected ambient probe), it could be due to a disconnected probe (reconnect it) or a faulty probe (replace it).
How to fix fan failure on a Fondital minorca rc?
If your Fondital Boiler is experiencing fan failure, it could be due to a disconnected fan (reconnect it) or a faulty fan (replace it).
What to do if the flow temperature exceeded the max allowed value in Fondital Boiler?
If your Fondital Boiler's flow temperature exceeds the maximum allowed value, it could be due to a faulty circulation pump (replace it) or a seized circulation pump (check the pump's electrical connection).
General| Energy Efficiency Class Heating | A |
|---|---|
| Energy Efficiency Class DHW | A |
| Heat Exchanger | Stainless Steel |
| Fuel Type | Natural gas / LPG |
| Control System | Electronic |
| Dimensions (H x W x D) | 700 x 400 x 230 mm |
| NOx Emissions | Class 5 |
| Ignition | Electronic |
To Next Page