What to do if my Fondital PANAREA COMPACT is not supplying DHW?
If your Fondital Boiler isn't supplying domestic hot water (DHW), it could be due to several reasons. The system might have insufficient pressure or flow rate, so you should check the DHW system. Additionally, inspect the DHW flow meter filter. The DHW flow meter sensor could be faulty, disconnected (replace or reconnect it), or blocked (replace it).
Why is no. 1 led on in red on my Fondital PANAREA COMPACT Boiler?
If the no. 1 LED is illuminated in red on your Fondital Boiler, it indicates that the water flow in the system is not adequate. Check the pump and the CH system.
What does it mean if no. 1 led is on in yellow on my Fondital PANAREA COMPACT?
If the no. 1 LED is illuminated in yellow on your Fondital Boiler, it suggests that the system is leaking, so check the CH system. Another possibility is that the water pressure switch is disconnected (reconnect it) or faulty (replace it).
What to do if my Fondital Boiler has shut down and no. 1 led is on in red?
If your Fondital Boiler has shut down and the no. 1 LED is illuminated red, it could be due to the CH water not flowing in the system because the pipes might be clogged, thermostatic valves might have shut, or system stopcocks might be closed, so check the CH system. Another cause might be that the pump is blocked or faulty, so check the pump.
Why is no. 1 led flashing yellow and red on my Fondital Boiler?
If the no. 1 LED is flashing yellow and red on your Fondital Boiler, it indicates that the CH probe is either disconnected (reconnect it) or faulty (replace it).
Why is no. 1 led flashing green and red on my Fondital PANAREA COMPACT?
If the no. 1 LED is flashing green and red on your Fondital Boiler, it means that the DHW probe is either disconnected (reconnect it) or faulty (replace it).
What does it mean if no. 1 led is flashing green on my Fondital PANAREA COMPACT?
If the no. 1 LED is flashing green on your Fondital Boiler, it suggests that the link between the PCB and gas valve is disconnected or faulty, so check the connection to the gas valve. Alternatively, the gas valve modulation coil might be faulty, and you should replace it.
What to do if my Fondital PANAREA COMPACT Boiler has shut down and no. 1 led is on in yellow?
If your Fondital Boiler has shut down and the no. 1 LED is illuminated yellow, it could be due to a weak air intake or flue gas discharge system, so check the air intake or flue gas discharge system and vent grilles in the boiler room. Another cause might be that the flue gas thermostat is faulty, so replace it.
What to do if my Fondital PANAREA COMPACT has shut down and no. 2 led is on in red?
If your Fondital Boiler has shut down and the no. 2 LED is illuminated red, it could be due to several reasons. First, there might be a gas supply failure, so check the gas pressure and the gas network stopcock or gas network safety valve. It's also possible the gas valve has disconnected and needs reconnecting, or the gas valve itself or the PCB is faulty and needs replacement. Other potential issues include a faulty electrode (replace it), a faulty PCB that doesn't ignite (replace PCB), incorrect neutral and phase connection sequence (verify correct neutral and phase connection sequence), an interrupted ignition/flame detection electrode wire (connect or replace it), a faulty ignition/flame detection electrode (replace electrode), a faulty PCB that doesn't detect flame (replace PCB), an ...
Explains the procedures for switching on and operating the boiler, including DHW and CH settings, and anti-frost function.
Covers general installation guidelines, emphasizing the use of manufacturer-approved accessories and spare parts for correct operation.
Outlines the step-by-step process for physically installing the boiler, cleaning pipes, and making connections.
Details requirements and safety considerations for the flue gas exhaust and air intake systems, including chimney connection.
Provides instructions and precautions for safely connecting the gas supply pipe to the boiler, including leak testing.
Guides on connecting central heating and domestic hot water pipes, including advice on water hardness and system cleaning.
Details the correct procedure for electrical power supply connections, safety measures like earthing and switches.
Provides essential preliminary checks and refers to user instructions for switching the boiler on and off.
Explains how to adapt the boiler for different gas types (Methane/LPG) and adjust burner settings for optimal performance.
Outlines the routine maintenance tasks and periodic checks required for the boiler to ensure efficiency and safety.
General| ErP Rating | A |
|---|---|
| Combustion Chamber | Sealed |
| Control Panel | Digital |
| Ignition | Electronic |
| Heat Exchanger Material | Stainless Steel |
| Power Output | 24 kW |
| Fuel Type | Natural gas / LPG |
| Dimensions (HxWxD) | 700 x 400 x 280 mm |
To Next Page