FoodSaver V3020 User Manual (English)

Questions and Answers:

J
Jimmy JonesJul 31, 2025
Why is the vacuum pump running but the FoodSaver bag is not evacuating?
- B
  Beth LarsenJul 31, 2025
  To address a FoodSaver vacuum pump running without evacuating the bag, ensure the open end of the bag is correctly placed inside the vacuum channel. Also, check for any wrinkles along the sealing strip and gently stretch the bag flat upon insertion. Verify the gaskets are properly inserted and free of foreign objects, dirt, or debris. Ensure the accessory hose is detached from the accessory port and the lid is fully latched. If the latch doesn't secure the lid, it may cause a leak. If you're using a roll, ensure one end of the bag is sealed. If the latch has been left closed, unlatch it and allow 10 to 20 minutes for the gaskets to expand.
G
gomezjessicaAug 6, 2025
What to do if the FoodSaver bag is not sealing properly?
- K
  Karen CarterAug 6, 2025
  If your FoodSaver bag isn't sealing properly, it might be due to too much liquid inside; try freezing the contents before vacuuming. Also, check the seal area for food debris; if present, remove the gasket, clean it, and reinsert it into the vacuum channel. Wrinkles in the bag can also prevent a proper seal; gently stretch the bag flat as you insert it into the vacuum channel.
S
Stephen LittleAug 11, 2025
Why is the red seal LED flashing on my FoodSaver?
- E
  Emily GordonAug 11, 2025
  The red seal LED flashing on your FoodSaver indicates one of several issues. The unit may be overheated; allow 20 seconds between seals, and if under heavy use, wait 20 minutes for it to cool down. Alternatively, the latch may have been left closed, compressing the gaskets; unlatch it and wait 10-20 minutes for them to expand. It can also mean that the vacuum pump has been running for more than 120 seconds. In this case, the appliance will shut off automatically and the red light will flash.
T
tpattersonAug 17, 2025
How to fix a FoodSaver with no lights on the control panel?
- A
  Andrew CruzAug 17, 2025
  If there are no lights on the control panel of your FoodSaver, first ensure that the unit is properly plugged in. Next, verify that the wall outlet is functional. Finally, check that the lid is completely closed and the latch is in the locked position.
T
Timothy HenryAug 25, 2025
What to do if the FoodSaver gasket is loose or has a tear?
- D
  Daniel BurgessAug 25, 2025
  To fix a loose or torn gasket on your FoodSaver, take out the gasket, clean it, and reinsert it into the vacuum channel.

FoodSaver V3020 Specifications

General

Type	Vacuum Sealer
Model	V3020
Brand	FoodSaver
Material	Plastic
Voltage	120V
Seal Type	Heat Seal
Sealing Width	11 inches
Country of Origin	China
Power Source	Electric
Operation	Automatic
Included Components	Vacuum Sealer, Starter Bags/Rolls
Warranty	1 year limited warranty
Color	Black