105
Troubleshooting
Caution! Make sure the appliance is switched o and the battery is
removed. Always wear protective gloves.
Problem Possible cause Solution
Motor does
not run
Battery empty Recharge battery
Unsuitable cutting areas Start on short or already
mown grass.
Blade is blocked Clean discharge chute and
housing (blade must rotate
freely)
Safety plug is not con-
nected
Connect safety plug
Battery is not correctly
inserted
Remove battery and insert
again
Wrong cutting height Set the wheels to the correct
cutting height
Motor power
drops
Wrong cutting height Set the wheels to the correct
cutting height
Discharge chute is
blocked
Clean discharge chute and
housing (blade must rotate
freely)
Poor and uneven cut Replace the blade (contact
service center)
Collection
bag is not
filled suitably
Unsuitable cutting areas Set the wheels to the correct
cutting height
Allow lawn to dry
Poor and uneven cut Replace the blade (contact
service center)
Collection bag is full Empty the collection bag
Discharge chute is
blocked
Clean discharge chute and
housing (blade must rotate
freely)
To Next Page
Loading...