Force F-G20-BASE - Installation Instructions: Step 2

Assembly step-2 drawing
16
Assembly step-2 installaon instrucon
1
Assembly rubber crush-30,safety catch-right-29,sliding sleeve-27 on front guide rod-2.
2
Assembly rubber crush-30,safety catch-le-31,sliding sleeve-27 on front guide rod-2.
3
Assembly barbell bar-28 on sliding sleeve-27.
4 Assembly finish assmbly front guide rod-2 on ground tube-1 using M10*20 hexagon bolt-18,Φ10 washer-8,Φ
10 spring gasket-19.
5
Assembly weight stack-130KG-33 on front guide rod-2.
6
Plug magnec pin-34 into weight stack-130KG-33.