Force F-G20-BASE - Installation Instructions: Step 6

30
Assembly step-6 drawing
Assembly step-6 installaon instrucon
1 Assembly Φ95 pulley-71 on main machine using M10*75 hexagon bolt-56,powder metallurgy sleeve-87,M10
lock nut-9.
2 As shown in the figure through wire-ball bolt-88 then fix it on pulley frame-85,weight stack-130KG-33,sliding
tube right-61.
3 As shown in the figure through wire-ball bolt-88 then fix it on pulley frame-85,weight stack-130KG-33,sliding
tube -le-63.
4 Assembly decorate adjust plate-86 on up decorate plate-53 using M10*75 hexagon bolt-56,Φ10 washer-
8,M10 lock nut-9 .