Force F-G20-BASE - Installation Instructions: Step 7

33
Assembly step-7 drawing
Assembly step-7 installaon instrucon
1 Assembly 3070 boom reinforcing plate-97 on ground tube-1 le stand tube-3 using M10*75 hexagon
bolt-56,Φ10 washer-8,M10 lock nut-9 .
2 Assembly 3070 boom reinforcing plate-97 on ground tube-1 right stand tube-5 using M10*75 hexagon
bolt-56,Φ10 washer-8,M10 lock nut-9 .
3 Assembly 3070 boom reinforcing plate-98 on 3070 boom reinforcing plate-97 using M10*75 hexagon
bolt-56,Φ10 washer-8,M10 lock nut-9 .
4 As shown in the figure through wire-nose nose-99.Fix wire-nose nose-99 on wire-hang nose-98 using
M10*25 hexagon bolt-100.
5
Fix wire-nose nose-99 on sliding tube right-61 using M10*25 hexagon bolt-100.
6
Fix wire-nose nose-99 on sliding tube -le-63 using M10*25 hexagon bolt-100.
，
，