SCOOT SKEET: HANDS-FREE DRONE User Manual
7
DRONE CHARGING SAFETY GUIDELINES
• Do not leave the drone unsupervised when charging
• Make sure there is no short circuit of the power wire
• Please use the recommended charger only. Do not charge on a gaming console. Only
use your computer’s USB port, power bank or phone wall charger to charge the battery
• To avoid trickle charging, always unplug the drone from the USB charger when storing
or leaving unattended
• Check the charger’s wire, plug, and surface regularly. Do not use a broken charger
• When drone is fully charged, do not try to charge further until it has been partially or
fully discharged
• Leave time between charging and using the drone
• Do NOT overcharge the drone. It may cause overheating and in turn this overheating
could damage the battery or melt/burn internal surfaces when charging
• Never try charging the drone if you feel the battery has been damaged, you run the
risk of fire
• Cells that are obviously swollen or have physical damage should never be used,
and careful disposal is required, especially if the cells are swollen; check the engine
assembly of the drone for swelling
Email us at support@force1rc.com for questions, comments or to request spare parts
DRONE CALIBRATION INSTRUCTIONS
Follow these steps to calibrate your drone
• Turn the power switch on
• The center light will flash, When the center light turn solid green, shake the drone back
and forth 3 to 5 times
• After shaking, the center light will flash, indicate the drone is in calibration mode
• Place the a flat surface while calibrates
• The drone is calibrated when the center light turns solid green
To Next Page
