Forcepoint 120 Series - Mount the 120 W Appliance on a Wall; Important Considerations; Mounting Requirements

Next Generation Firewall Hardware Guide | Model 120W
If the plug-and-play configuration method is not used, the on-site installer must use the USB drive that
contains the initial configuration files to configure the NGFW Engine software.
3) When you have finished installing the appliance, inform the SMC administrator so that the administrator can
check the status of the appliance in the Management Client.
Attach the antennas
Attach the three antennas included in the delivery to the appliance.
Before you begin
Before you attach or replace the antennas, you must turn off the appliance.
Steps
1) Locate the antennas included in the appliance delivery.
2) Attach the antennas to the connectors on the back panel of the appliance.
3) Tighten the knurled nuts at the base of the antennas to secure them firmly to the appliance.
4) While holding the base of the antennas, position the antennas.
Mount the 120W appliance on a wall
You can optionally mount the 120W appliance on a wall.
Important
There are vents on the sides of the appliance. Keep other objects at least 100mm (4 inches) away
from the appliance to ensure good air flow. Do not stack appliances.
Mounting the appliance on a wall has the following requirements:
■
You can mount the appliance in a horizontal orientation only with the connectors for the cables facing down.
■
The distance between the holes that you drill for the appliance in the wall must be 120mm (4.7 inches).
■
Depending on the wall material, you might need to insert nylon plugs into the mounting holes that you drill for
the appliance. No nylon plugs are supplied with the appliance.
■
Two flat undercut screws are required. No screws are supplied with the appliance.
The diameter of the screw heads must be 5.5mm (7/32 inch) and the thickness of the screw heads must be
2mm (5/64 inch).
Select screws that are suitable for the wall material and long enough to provide a firm mounting point for the
appliance. If you have attached the four provided rubber feet to the bottom of the appliance, make sure that
the screws are long enough to provide a firm mounting point for the appliance with the feet attached.
9