seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink!. The indicator light will
flash slowly and then rapidly after HomeLink! accepts the radio
frequency signal.
• Proceed with Step 4 in the “Programming” section.
Operating the HomeLink# Wireless Control System
To operate, simply press and release
the appropriate HomeLink! button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLink! at www.homelink.com or 1–800–355–3515.
Erasing HomeLink# buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink! buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink! is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the “Programming” section.
Reprogramming a single HomeLink# button
To program a device to HomeLink! using a HomeLink! button previously
trained, follow these steps:
1. Press and hold the desired HomeLink! button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink! button, follow Step 2 in the “Programming”
section.
2007 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
106
To Next Page
Loading...
Need help?
General
