Note: Keep the rear bumper area
surrounding the sensors free from dirt, ice
and snow.
If a sensor becomes blocked the system
performance may degrade. A blocked
sensor message may be displayed.
The system will automatically return to
normal operation after one of the following
conditions have been met:
• Two other vehicles have been detected
on both sides.
• You switch the ignition off and on.
If the sensor remains blocked after you
have switched the ignition off and on, the
system will detect the blockage again and
alert you.
Trailer Towing False Alerts
If your vehicle has a trailer tow module
approved by us, the system will detect a
connected trailer and turn off. A
confirmation message will be shown in the
information display. See Information
Messages (page 68). The warning
indicator in the instrument cluster will
illuminate. See Warning Lamps and
Indicators (page 59).
Note: If your vehicle has a trailer tow
module not approved by us, the system may
not correctly detect a connected trailer.
Switch the system off to avoid false alerts.
See Information Displays (page 63).
SPEED LIMITER
Principle of Operation
WARNING
When you are going downhill, your
speed may increase above the set
speed. The system will not apply the
brakes but a warning will be given.
The system allows you to set a speed, to
which your vehicle then becomes limited.
The set speed will become the effective
maximum speed of your vehicle, but with
the option to temporarily exceed this limit
if required.
Using the System
Note: The set speed limit can be
intentionally exceeded for a short period of
time if required, for example when
overtaking.
The system is operated by adjustment
controls mounted on the steering
wheel.
To Next Page
Loading...
