DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES
Cylinder Block Assembly
Disassembly
1. Mount the engine (6007) on a work stand and remove all parts not furnished with the new cylinder
assembly.
2. Remove the old cylinder assembly from the work stand.
A
ssembly
1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.
2. Position the new cylinder assembly in a work stand and transfer all serviceable parts removed from
the old cylinder assembly.
3. Check all assembly clearances and correct as necessary.
Section 03-01C: Engine, 4.0L V-6 1997 Aerostar, Ranger Workshop Manual
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C48.HTM~gen~ref.HTM
To Next Page
Loading...
Need help?
General
