2. Perform the High Voltage system depower procedure found in the previous section. This section includes information on disconnecting
the 12v batteries.
NOTICE:
Apply tape surrounding the charge port door to prevent damage to the fender.
3. Using a flat blade screwdriver and a hammer knock out the four bezel clips. Pry the retaining tabs away from the sheet metal and pull the
charge port housing out at each corner. Please see the illustrations below.
3-4 High Voltage Charge Cord Lock — Manual Release
Section 3: High Voltage Charge Cord Lock Manual
Release
2020 Explorer / Aviator Hybrid Vehicle Emergency Response Guide - 09/2019
To Next Page
Loading...
