3. Press the wiper blade secondary
locking clip.
4. Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
5. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
WASHERS
WASHER PRECAUTIONS
WARNING: If you operate your
vehicle in temperatures below 41°F
(5°C), use washer fluid with antifreeze
protection. Failure to use washer fluid
with antifreeze protection in cold
weather could result in impaired
windshield vision and increase the risk
of injury or accident.
Do not operate the washers when the
washer reservoir is empty. This could cause
the washer pump to overheat.
Keep the outside of the windshield clean.
The rain sensor is very sensitive and the
wipers may operate if dirt, mist or insects
hit the windshield.
USING THE WINDSHIELD WASHER
Press and hold the button at the
end of the lever to operate the
windshield washer.
Note: A courtesy wipe occurs a short time
after the wipers stop to clear any remaining
washer fluid when switched on. See
Switching the Courtesy Wipe On and Off
(page 112).
SWITCHING THE COURTESY WIPE
ON AND OFF - VEHICLES WITH:
12.3 INCH SCREEN
1. Press Settings on the touchscreen.
2. Press Vehicle Settings.
3. Press Wipers.
4. Switch Courtesy Wipe on or off.
SWITCHING THE COURTESY WIPE
ON AND OFF - VEHICLES WITH: 15
INCH SCREEN
1. Access the vehicle drawer on the
touchscreen.
2. Press SETTINGS.
112
F-150 Lightning (TFD) Electric, Canada/United States of America, enUSA, Edition date: 202112, First-Printing
Wipers and Washers
To Next Page
Loading...
