USING THE VALET MODE
Classic Valet Mode
Enabling Valet Mode
Make sure the remote control is in your
vehicle.
1. Access the vehicle drawer on the
touchscreen.
2. Press CONTROLS.
3. Press Valet Mode.
4. Enter a four digit code to lock the
touchscreen.
5. Re-enter the same four digit code to
complete enabling valet mode.
Disabling Valet Mode
1. Press Exit Valet Mode.
2. Enter your four digit code to disable
valet mode and unlock your
touchscreen.
Enhanced Valet Mode
Enabling Valet Mode
Have your backup start passcode
completely set up before using valet mode.
See Programming Your Phone (page
72).
Note: If your vehicle detects a remote
control, the system defaults to classic valet
mode.
1. Access the vehicle drawer on the
touchscreen.
2. Press CONTROLS.
3. Press Valet Mode.
Note: If the system detects a valid phone
as a key, the temporary passcode displays
in both the touchscreen and mobile app.
Note: If the system does not detect a valid
phone as a key, it prompts you to enter your
backup start passcode on the touchscreen.
Once validated, the temporary passcode
displays on the touchscreen.
4. Provide the valet the first five digits of
the passcode to enter on the keyless
entry keypad to unlock your vehicle.
5. Provide the valet the eight-digit
passcode to enter on the touchscreen
to start and drive your vehicle.
Disabling Valet Mode
1. Press Exit Valet Mode.
Note: If the system detects an authorized
phone as a key, valet mode disables.
Note: If the system does not detect a valid
phone as a key, it prompts you to enter your
backup start passcode. Once validated,
valet mode disables.
USING THE BACKUP START
PASSCODE
Make sure you have phone as a key active
on at least one phone to use a previously
created backup start passcode. See
Programming Your Phone (page 72).
1. Press the brake pedal and the push
button start. If the system does not
detect a valid phone as a key or remote
control, a message appears on the
touchscreen and prompts you for your
backup start passcode.
Note: The touchscreen times out after 30
seconds with no interaction.
Note: If the backup start passcode screen
does not appear, press the brake pedal and
push button start again.
2. Use the touchscreen to enter your
backup start passcode.
3. After entering your passcode, press
return within 30 seconds.
73
F-150 Lightning (TFD) Electric, Canada/United States of America, enUSA, Edition date: 202112, First-Printing
Phone as a Key (If Equipped)
To Next Page
Loading...
