3. Remove the red cap. Connect the
positive (+) jumper cable to the
positive (+) jump point of the
discharged battery vehicle.
4. Connect the other end of the positive
(+) jumper cable to the positive (+)
terminal of the booster vehicle battery.
5. Connect the negative (-) jumper cable
to the negative (-) terminal of the
booster vehicle battery.
6. Make the final connection of the
negative (-) jumper cable to the
negative (-) ground point of the
discharged battery vehicle.
JUMP STARTING THE VEHICLE
To Start Your Vehicle
1. Run the engine of the booster vehicle
at a moderately high speed.
2. Move the transmission selector lever
of the low charge vehicle to park (P).
3. Switch on the ready to drive mode. See
Starting the Vehicle (page 194).
4. Run both vehicles for a minimum of
three minutes before disconnecting the
cables.
Note: Do not switch the headlamps on
when disconnecting the cables. The peak
voltage could damage the bulbs.
Disconnect the cables in the reverse order.
POST-CRASH ALERT SYSTEM
WHAT IS THE POST-CRASH
ALERT SYSTEM
The system helps draw attention to your
vehicle in the event of a serious impact.
HOW DOES THE POST-CRASH
ALERT SYSTEM WORK
The system is designed to turn the hazard
flashers on and to intermittently sound the
horn in the event of a serious impact that
deploys an airbag or the seatbelt
pretensioners.
POST-CRASH ALERT SYSTEM
LIMITATIONS
Depending on applicable laws in the
country your vehicle was built for, the horn
does not sound in the event of a serious
impact.
421
F-150 Lightning (TFD) Electric, Canada/United States of America, enUSA, Edition date: 202112, First-Printing
Crash and Breakdown Information
To Next Page
Loading...
