Ford FD7200S - Oil Filter Replacement

Fuel filter must often clean, ensure a maximum output power for diesel engine.
• Put the fuel tank of fuel.
• Loosen the tubing clamp, screw, nut, diesel thoroughly clean the filter.
• Serious condition, replace the fuel filter.
Bolted fixed fuel filter.•
Fuel tank must be empty before replacing fuel filter. Run unit until tank is empty, if needed,
or inspect filter prior to fill-up.
Fig 17
· Loosen the lock nut, remove the oil filter with a clean petrol or
kerosene wash.
Pay attention to the oil filter gasket don't break.
Install oil filter back in box.
·
·
Oil Filter (See Fig 17)
Oil Filter
22
Draining Fuel Tank
To help prevent gum deposits in the fuel system, drain the fuel from the tank and carburetor before storing the unit for long
periods of time. This will help prevent starting problems in the future. If the unit is stored with fuel and the fuel becomes
stale or turns gummy or to varnish the warranty does not cover this repair or service.
Draining the fuel tank
Turn the engine OFF.
• Turn the fuel valve to the OFF position.
• Remove the fuel line that leads to the carburetor from the petcock by squeezing the ends of the hose clamps and
sliding the fuel line off.
• If needed, install a fuel hose that will extend to a suitable fuel container large enough to catch the fuel being drained
from the tank.
• Turn the fuel valve to the ON position.
• When the fuel has drained from the tank, close the fuel valve and reinstall fuel line securely on petcock.
•
W
WCAUTION!