Select the wiper switch to position B for
intermittent wiping.
However wiping delay can be programmed
as follows.
1. Switch on the ignition.
2. Set the wiper switch to intermittent
position.
3. Move the wiper switch to off position
when the wiper comes to park position.
Note: Wiping delay timing will start from
here to until the wiper switch is moved to
position B.
4. Move the wiper back to position B for
the required time delay.
Note: The user programmed timer resets,
when the wiper switch is moved to low/high
speed or when the ignition is switched off.
Variable intermittent
WARNING
Do not operate the windscreen
washer for more than 10 seconds or
when the reservoir is empty.
28
Wipers and Washers