GENERAL INFORMATION
WARNING
Do not operate the information
display controls when the vehicle is
moving. The driver should at all times
be alert and focus his attention on the road
ahead only.
Note: The information display will remain
on for several minutes after you switch off
the ignition.
Information display
OdometerA
TripmeterB
Distance to emptyC
Reset buttonD
Press the reset button to scroll through the
displays.
Note: The information display illuminates
when the driver door is opened.
Display definitions
Tripmeter
Note: The maximum value for tripmeter is
9999.9kms and after that it automatically
resets and starts from zero.
The tripmeter can register the mileage of
individual journeys.
Distance to empty
Indicates the approximate distance that
your vehicle will travel on the fuel in the
fuel tank.
Distance to empty display will stay on for
approximately 5 seconds when the igntion
is switched on and then cluster will go back
to the pre-set mode.
Odometer
Note: The maximum value for odometer
measurement is 999,999 kms after that it
automatically resets and starts from zero.
Registers the total mileage of the vehicle.
Reset button
A short press toggles the display between
odometer/trip/distance to empty.
A long press of more than two seconds
resets the trip to zero.
46
Information Displays
To Next Page
Loading...
