Ford FIGO - Changing the 12 V Battery; Checking the Wiper Blades

When adding fluid, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
For information on fluid dilution, refer to
the product instructions.
CHANGING THE 12V BATTERY
WARNING
You must replace the battery with
one of exactly the same
specification.
The battery is located in the engine
compartment.
To remove and install the battery:
E174484
1
2
1. Loosen the nuts from the terminals.
Remove the negative battery cable first
(1), then the positive battery cable (2).
E164691
2. Remove the two nuts from the clamp.
3. Remove the battery.
4. Install in the reverse order.
Note: The acid solution and lead contained
in the battery, if discarded improperly in
nature, can contaminate soil, subsoil and
water, as well as cause damage to human
health.
CHECKING THE WIPER
BLADES
E203709
Run the tip of your fingers over the edge of
the blade to check for roughness.
131
Figo (CDU) , E4B5 19A321 ZCA enIND, Edition date: 06/2015, Second Printing
Maintenance