Ford FIGO - Changing a Bulb - 4-Door

Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector correctly.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the lower fixing point.
CHANGING A BULB - 4-DOOR
WARNINGS
Switch the lamps and the ignition off.
Let the bulb cool down before
removing it.
Do not touch the bulb glass.
Note: Only fit bulbs of the correct
specification.
See Bulb Specification Chart (page 139).
Note: The following instructions describe
how to remove the bulbs. Fit replacements
in the reverse order unless otherwise stated.
Headlamp
Note: Remove the covers to gain access to
the bulbs.
A
B C
E174675
Headlamp low and high beamA
Direction indicatorB
Position lampC
Headlamp Low and High Beam
2
3
E174676
1. Disconnect the electrical connector.
2. Remove the cover.
3. Release the clip and remove the bulb.
Note: Do not touch the bulb glass.
Position Lamp
2
3
E176168
1. Disconnect the electrical connector.
2. Turn the bulb holder counterclockwise
and remove it.
3. Press the bulb in and turn the bulb
counterclockwise to remove it.
Direction Indicator
1. Disconnect the electrical connector.
134
Figo (CDU) , E4B5 19A321 ZCA enIND, Edition date: 06/2015, Second Printing
Maintenance