ISOFIX ANCHOR POINTS
WARNING
Use an anti-rotation device when
using the ISOFIX system. We
recommend the use of a top tether
or support leg.
Note: When you are purchasing an ISOFIX
restraint, make sure that you know the
correct mass group and ISOFIX size class
for the intended seating locations. See
Child Seat Positioning (page 23).
Your vehicle is fitted with ISOFIX anchor
points that accommodate universally
approved ISOFIX child restraints.
The ISOFIX system comprises two rigid
attachment arms on the child restraint that
attach to anchor points on the outboard
rear seats, where the cushion and backrest
meet. Tether anchor points are fitted
behind the outboard rear seats for child
restraints with a top tether.
Top tether anchor points
Attaching a child seat with top
tethers
WARNING
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Note: Where applicable, remove the
luggage cover to ease installation. See
Luggage Covers (page 202).
1. Remove the head restraint. See Head
Restraints (page 126).
WARNING
Make sure that the top tether strap
is not slack or twisted and is properly
located on the anchor point.
2. Route the tether strap to the anchor
point.
3. Push the child seat back firmly to
engage the ISOFIX lower anchor points.
4. Tighten the tether strap in line with the
child seat manufacturer's instructions.
26
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Child Safety