Ford Ranger 2008 - Page 144

Black plate (144,1)
qClock
Clock button
Hour set button
Display
Minute set button
Setting the time
The clock can be set at any time when the
ignition switch is in the ACC or ON
position.
1. To adjust the time, press the clock
button (
) for about 2 seconds
until a beep is heard.
The clock's current time will flash.
2. To advance the hours, press the hour
set button (
). To advance the
minutes, press the minute set button
(
) while the time is flashing.
3. Press the clock button (
) again
to start the clock.
NOTE
To switch between '12Hr' and '24Hr'
time displays, press the display switch
buttons (
, ) while the time is
flashing.
Exact hour adjustment
1. To set the exact hour, press the clock
button (
) for about 2 seconds
until a beep is heard.
The clock's current time will flash.
2. Press the clock button (
) again
and the time will be adjusted as
follows:
(Example)
12:01―12:29→12:00
12:30―12:59→1:00
6-22
Interior Comfort
Audio System
RANGER_F8M1-10-08I_Edition1 Page144
Friday, September 26 2008 3:6 PM
Form No.F8M1-10-08I