You can adjust the warning system's
sensitivity through your information
display. See General Information (page
67). .
Note: When possible, the manufacturer
recommends using the highest sensitivity
setting. If warnings are too frequent, you can
reduce your system's sensitivity. Reduced
sensitivity causes fewer and later system
warnings. See General Information (page
67). .
Distance Alert
If the system detects that your vehicle is
too close to the vehicle in front based on
the current sensitivity setting (see
Adjusting Pre-Collision Assist Settings
section below) the centre section of the
red light bar in the windscreen will
illuminate (refer to image).
Distance Indication
Distance indication is a function that
provides a graphical indication of the time
gap to other vehicles traveling in the same
direction.
Note: Distance Alert and Distance
Indication deactivates when adaptive cruise
control is active. The distance indication
graphics do not display in the information
display unless adaptive cruise control is OFF.
Time GapDistance GapGraphicsSensitivitySpeed
up to 0.9
seconds
up to
25 m
GreyNormal100 km/h
between 0.6
seconds and 0.9
seconds
between
17 m
and
YellowNormal100 km/h
25 m
under 0.6
seconds
up to
17 m
RedNormal100 km/h
161
Ranger (), EB3B-19G219-ZAB enAUS
Driving Aids