System Warning Lamps
ActionDescriptionWarning lamp
1. Make sure tires are at the correct
pressure. See Wheels and Tires
(page 249). The tire pressures are also
on the tire inflation pressure label
(located on the edge of driver door
or the B-Pillar).
2. After inflating the tires to the correct
pressure you must carry out the tire
pressure monitoring system reset
procedure. See Tire Pressure
Monitoring System Reset
Procedure in this chapter.
Tire(s) under-inflatedSolid warning lamp
Repair the damaged road wheel and tire
and refit the repaired road wheel and tire
assembly to your vehicle to restore the
correct operation of the system.
Spare tire in use
If the tires are correctly inflated and the
spare tire is not in use but the light
remains on, the system has detected a
fault that requires service.
Tire pressure monitoring
system malfunction
Repair the damaged road wheel and tire
and refit the repaired road wheel and tire
assembly to your vehicle to restore the
correct operation of the system.
Spare tire in useSolid warning lamp
initially followed by
a flashing warning
lamp
If the tires are correctly inflated and the
spare tire is not in use but the light
remains on, the system has detected a
fault that requires service.
Tire pressure monitoring
system malfunction
If the Warning Lamp is On:
1. Check each tire to verify that none are
flat.
2. If one or more tires are flat, repair as
necessary.
3. Check the tire pressures and inflate all
the tires to the correct pressure.
4. Carry out the tire pressure monitoring
system reset procedure.
Tire Pressure Monitoring System
Reset Procedure
Overview
You must carry out the system reset
procedure after each tire replacement or
adjustment of the tire pressures.
257
Ranger (), EB3B-19G219-ZAB enAUS
Wheels and Tires
To Next Page
Loading...
Need help?
General
